Slitting Burr Control: Effects of Knife Clearance, Tension and Incoming Material

ARTICLE

👁 1

⏱ 阅读约 1 分钟

slitting · processing · quality

The four main causes of out-of-spec slitting burrs and the adjustment sequence, with common tolerance references.

Burr height depends on knife clearance (typically 5-8% of thickness), tension, knife wear and incoming edge quality. Check clearance first, then tension, then knife condition.

本文由 SteelWe 编辑与行业专家整理，内容仅供行业交流参考，不构成交易或投资建议。引用请注明来源。

Slitting Burr Control: Effects of Knife Clearance, Tension and Incoming Material

The four main causes of out-of-spec slitting burrs and the adjustment sequence, with common tolerance references.

Burr height depends on knife clearance (typically 5-8% of thickness), tension, knife wear and incoming edge quality. Check clearance first, then tension, then knife condition.

本文由 SteelWe 编辑与行业专家整理，内容仅供行业交流参考，不构成交易或投资建议。引用请注明来源。